well i got the drawers to one of the base cabinets assembled and installed. then i took a look around the shop and it was in such a state that i decided to clean it up a little bit. so while i do this, why don't you watch that. in part one of this vanity dresser build,i assembled the two base units and cut the drawer sides whilethose were drying in the clamps. short work of the dadoes i need for the drawerbottoms. make a single pass for each side. adjust myfence about an eigth of an inch. make a second pass. check the fit. everything looks good so i'll finish up here.
next i'll cut the drawer bottoms to size. these eight foot ceilings are a pain in my...ankle.you thought i was going to say it was a pain in something else didn't you. naughty you. cut to width. then to length. i've decided on dowels to assemble the drawersso i need a whole mess of one and a half inch dowels. every inch or so should be good on these dowels. alright lets assemble some dresser drawers. once i got a couple dowels set i realizedi could remove the clamps and do that last dowel. that'll clean up nice with some light sanding.
now i can slide the bottom in place. and finish up the other side. sand everything flush and then i'll take asponge to those top edges. i'm not trying to round over anything over, just take thebite out of them. once that's done i'll start cutting the facefronts to rough length. this is a solid piece of one by eight oak. i'll cut em a quarter inch longer than i needand then take them over to the table saw and make a pass to square up one side. then i'll do a final measurement, add a stopblock and square up the other side.
a quick check to make sure everything cameout ok. now i'll chamfer the edges. have i mentionedi like simple? and easy...i like simple and easy. a friend of mine came over one day and saidsomeone gave him an old bed frame that had storage underneath. he was going to breakit down for firewood and asked if i wanted any of the hardware from it. ahhhh....yeah!!! i'll find a use for those. i'll just clean these up a little bit andthey'll work just fine. there, use found. i know the overhang measurements so i'll markthose.
lay the drawer on top and line em up withthe marks. evan though i didn't get to staining i'd sayshe's still coming along pretty well. i'll get to that next time, maybe start addingsome trim pieces and i've gotta start thinking about the top as well. hey thanks for watching. subscribe if you haven't. check me out of facebook and pinterest. if you like this video, here is a couple more you'll like as well. until then.
Komentar
Posting Komentar