woodworking plans jewelry cabinet

the logo is very complex there are two v-inlays i have to insert the second inlay at the next stage the board bent a little because of large amount of glue i didn't fully sand the edges of the board because i could sand off the letters in the middle i will dry the board later and thus make it flat the second attempt was also unsuccessful the board cracked after strong clamping

so i have to make the third attempt it would be better to use a big sheet of plywood i decided to finish this board it will be impossible to use it as cutting board i filled the cracks with the glue and clamped the board the cracks are almost invisible i will use this board as decorative one after lacquering.